OneWaySpikes.com
Open weekdays 8 AM- 4PM
520-780-9751
COBRA™ Surface Mount Traffic Spike System
12300.100 - 3′ (914mm) – Safety Red - 114 lbs.
End Bevel – Set of 2 – Part #12300.190
12300.120 - 3′ (914mm) – Galvanized & Powder Coated Safety Red - 114 lbs.
End Bevel – Set of 2 – Part #12300.192
12300.130 - 3′ (914mm) - Powder Coated Safety Red - 114 lbs.
End Bevel - Set of 2 – Part #12300.194
- ¼” Steel Top Plate
- Top Down Design- Not Bottom Up
- Counter Balanced & Spring Loaded
- Heavy Duty Steel Construction
- Reliable Zinc Plated Moving Parts
- Positive Stop Eliminates Wear
- Specially Engineered Teeth
- Built-In Latch Down Device
- End Bevels Recommended
- Conditioned for Heater Cable System
- Load Rated: 7.5 Tons or 15,000 lbs per Single Axle Load
- Made in the USA
The COBRA™ can be used in all commercial and residential applications. These surface mounted traffic spikes are easy to install on asphalt and concrete surfaces. The COBRA™ unit also serves as a traffic calming speed bump.
Traffic Spike Warning Signs must be used with one way directional control traffic spikes to warn drivers that a one-way traffic lane exists and that severe tire damage may occur.
Mounts to a 2 3/8" OD Pipe Post
Traffic Spike Warning Signs Should Always Be Installed to Warn Drivers & Pedestrians
5 MPH Rule Needs to Be Strictly Enforced When Crossing One Way Directional Traffic Control Spikes.
Use Speed Bumps to control vehicle speed if necessary.
2 Sided Reflective 18"X24" Warning Sign
Heavy Gauge Aluminum Insert Surrounded by a 14 Gauge Steel Tube Frame and a mounting point for a 2 3/8" OD Pipe Post. This sign is highly reflective and requires no power source.
NO POWER REQUIRED - HIGHLY REFLECTIVE
Traffic Spike Warning Sign - Reflective No Electricity Required
5 MPH Rule must be strictly enforced when crossing any directional traffic spike system
The COBRA™is a perfect addition to an automatic gate. Double the protection for your exit gates. Eliminate vehicles entering through exit gates.
The COBRA ™ has a modular design that enables wide road coverage. Each spike unit is 36" in width. Install as many as are needed to protect your traffic lane.
Traffic Spike Warning Signs - Illuminated - Power is Required
Mounts to a 3" OD Pipe Post
Not Supplied
• Warning sign includes automatic light sensor
• Two 20-watt fluorescent bulbs
• Flood lamp to illuminate spikes
• Mounts on 3" post (not supplied)
24" H x 24" W x 8" D
61cm W x 61cm H x 20.3cm D
Operates on 115 VAC, 1.75 Amp
Two 20-watt fluorescent bulbs
150-watt flood lamp
Built-in light sensor
Secure On/Off switch
Galvanized steel housing painted white
ETL Listed
A Warning Sign is typically used with traffic control spikes to warn drivers that a one-way lane condition exists and that proceeding through the lane in the wrong direction will result in severe tire damage. The red side of the sign warns drivers to stop, while the green side warns them not to back up. With the built-in light sensor, the sign automatically illuminates at dusk and turns off at dawn.
Copyright © 2015 Secure Lane LLC, All Rights Reserved | All Sales are Final Terms
Contact the webmaster at: [email protected]
3220 S Dodge Blvd #8 Tucson, AZ 85713 USA (520)780-9751
