OneWaySpikes.com
Open weekdays 8 AM- 4PM
520-780-9751
KING COBRA™ Heavy Duty Surface Mount Traffic
Spike System
12360.100 - 3′ (914mm) – Safety Red - 132 lbs.
End Bevel – Set of 2 – Part #12360.190
12360.120 - 3′ (914mm) – Galvanized & Powder Coated Safety Red - 132 lbs.
End Bevel – Set of 2 – Part #12360.192
12360.130 - 3′ (914mm) - Powder Coated Safety Red - 132 lbs.
End Bevel - Set of 2 – Part #12360.194
- 3/8” Steel Top Plate
- Top Down Design – Not Bottom Up
- Durable Counter Balanced System and Spring Loaded
- Heavy Duty Steel Construction
- Reliable Zinc Plated Moving Parts
- Positive Stop Eliminates Wear
- Specially Engineered Teeth
- Stainless Steel Hardware
- Built-In Latch Down Device
- End Bevels Recommended
- Load Rated: 18 Tons or 36,000 lbs per Single Axle Load
- One Year Limited Warranty
- Made in the USA
- Recommended 7″ End Bevels – Set of Two – Part #12360.190
- Conditioned for Heater Cable System
18 Tons Per Axle Load
The KING COBRA™ can be used in all commercial applications. These surface mounted traffic spikes are easy to install on asphalt and concrete surfaces. Easy to maintain with the top down design. Just unbolt, lift top, clean out debris, replace top, bolt down and your done!
KING COBRA™ traffic spike system is truck tough! The KING COBRA™ unit also serves as a traffic calming speed bump that will keep the required 5 MPH speed limit enforced.
Traffic Spike Warning Signs must be used with one way directional control traffic spikes to warn drivers that a one-way traffic lane exists and that severe tire damage may occur.
Mounts to a 2 3/8" OD Pipe Post
Traffic Spike Warning Signs Should Always Be Installed to Warn Drivers & Pedestrians
5 MPH Rule Needs to Be Strictly Enforced When Crossing One Way Directional Traffic Control Spikes.
Use Speed Bumps to control vehicle speed if necessary.
2 Sided Reflective 18"X24" Warning Sign
Heavy Gauge Aluminum Insert Surrounded by a 14 Gauge Steel Tube Frame and a mounting point for a 2 3/8" OD Pipe Post. This sign is highly reflective and requires no power source.
NO POWER REQUIRED - HIGHLY REFLECTIVE
Traffic Spike Warning Sign - Reflective No Electricity Required
5 MPH Rule must be strictly enforced when crossing any directional traffic spike system
Traffic Spike Warning Signs - Lighted Power is Required
Mounts to a 3" OD Pipe Post
Not Supplied
• Warning sign includes automatic light sensor
• Two 20-watt fluorescent bulbs
• Flood lamp to illuminate spikes
• Mounts on 3" post (not supplied)
24" H x 24" W x 8" D
61cm W x 61cm H x 20.3cm D
Operates on 115 VAC, 1.75 Amp
Two 20-watt fluorescent bulbs
150-watt flood lamp
Built-in light sensor
Secure On/Off switch
Galvanized steel housing painted white
ETL Listed
A Warning Sign is typically used with traffic control spikes to warn drivers that a one-way lane condition exists and that proceeding through the lane in the wrong direction will result in severe tire damage. The red side of the sign warns drivers to stop, while the green side warns them not to back up. With the built-in light sensor, the sign automatically illuminates at dusk and turns off at dawn.
Copyright © 2015 Secure Lane LLC, All Rights Reserved | All Sales are Final Terms
Contact the webmaster at: [email protected]
3220 S Dodge Blvd #8 Tucson, AZ 85713 USA (520)780-9751
